Tuesday, August 19, 2014

Ford 10-Cut Ignition Tip

Like most locksmith technicians, using a roll pins to prevent the ears from spinning on a ford 10 cut ignition is a nice way to repair the problem. However, I have found that a .350 lab pan also works well. Simply align the keyway face plate (use a blank key) and drill the proper sized hole. Put in a dab of superglue or Loctite then the lab pin and the job is finished.

although the role pin is very secure, I have found that the lab pin works just as well and only takes about 10 minutes to do the entire job. Fast, simple and easy. And best of all, we all have pinning kits on the truck, so there’s little hunting for the right part to do the job


No comments:

Post a Comment

Note: Only a member of this blog may post a comment.